ADVERTISEMENT
Instructions:
Phase 1:
Take 7 pieces of plastic bottles and give them a round shape. Wrap them with tape, then add another layer of plastic bottles and secure them with tape. Cut two circles from plywood, the same size as the diameter of the glued plastic bottles. Mark the center and 5 points around it. Drill the screws at the points, then repeat the operation on the other side.
Level 2:
Wrap the polyester wadding and sew the ends. Secure the bottom ends to the wood with staples. Fill the top with putty and close the wadding. Next, make the cover with the polyester lining fabric, then staple the bottom to secure.
Candle holder
Materials:
2 plastic bottles
hot glue
candela
Instructions:
Cut off the tops of two plastic bottles. Make sure the caps are closed. Glue the caps, then insert the candle at one end.
Sponge holder
Cut off the top and bottom of a plastic bottle. Insert the top part into the bottom part and use it to hold the sponge.
Potato basket
Make a small hole on one side and insert the potatoes.
DIY duct tape device
Materials:
plastic fork
plastic bottle
popsicle stick
Instructions:
Cut off the top of the plastic bottle and remove the cap. Cut a small piece of the knife edge and glue it to the top of the bottle. Make sure it overlaps and the bristles are facing outward. Insert the end of the ribbon into the bottle. To prevent it from moving, insert a popsicle stick into the tape.
Container for screws or nails
Cut off the top of the bottle. Cut the balloon in the center and insert it into the plastic bottle.
Hologram 3D
Cut off the cap and bottom of the bottle, leaving only the cone shape. Fold it in the center twice to get 4 corners. Place it on the right side of the mobile phone.
ADVERTISEMENT
